Clean workshop cleaning operation process
Author: Zhuo for air-conditioning purification Electromechanical Engineering Co., Ltd
Published:2017-09-18 15:56:57Views:2821【SML】
Vertical plate cleaning is mainly to highlight the wall or concave the wall of the site; such as: a set of indoor electrical box at the top, trunking, pipelines, fire hydrants, glass windows, back to the wind and other wall stains clean up.
Text label:
Clean workshop cleaning operation process
First, the operation of the process for the factory clean operation of the workshop will play a guiding and reference
Second, the required cleaning tools and products
(1), clean room dedicated vacuum cleaner
(2), clean paper, clean cloth, rag
(3), deionized water / filtered clean water
(4), alcohol
(5), bucket
(6), mop
(7), mop special barrels
Third, clean requirements
A. early clear
1, tools: to drag, rags, cleaning agents.
2, the main target: for the construction of the dust generated by cleaning
Steps: Ceiling - Wall - Ground.
note:
1. Smallpox dust, extra glass glue, dust outside the lamp, corner
clean, open hole or positioning drawing lines such as handwriting clean.
2. Vertical plate cleaning is mainly to highlight the wall or concave
the wall of the site; such as: a set of indoor electrical box at the
top, trunking, pipelines, fire hydrants, glass windows, back to the wind
and other wall stains clean up.
3. Ground parts, back to the internal dust column dust removal, ground
equipment and configuration equipment clean-up; such as: work tables,
shoe, round edge, corner and so on.
4. Maintenance of the room, into the indoor staff need to carry out dust treatment. (Wear clean clothes, set foot pad)
After the above cleaning is complete, proceed to the next step.
B. fine (to ensure that the room has a certain degree of cleanliness,
the air conditioning system to run up, you can carry out the indoor fine
work)
1, clean clean room wall should use clean room clean cloth;
2, with 90% deionized water and 10% isopropanol configuration detergent;
3, the use of approved clean room dedicated detergent;
4, every day to check the workshop and the preparation of the trash, and in time to clear away.
5, each floor should be dust. Each shift should indicate the completion of the job on the map, for example, where to end.
6, clean clean room ground should use a dedicated mop.
7, in the clean room, dust should be used with a high efficiency filter dedicated vacuum cleaner.
8, all the doors need to check and dry
9, after eating and then wipe the ground. Wipe the wall once a week.
10, overhead floor also have to clean and wipe.
11, three months to rub an overhead floor under the pillars and support column.
12, must remember when working, always rub up from the top, from the
furthest away from the door to the direction of the door rub.
Fourth, clean room cleaning procedures (if no project down implementation)
(1), replace the special anti-static clothing, wearing a hat, masks,
dust filter by the wind after the dust, into the clean room.
(2), prepare cleaning tools and supplies and place them in the specified location, start cleaning work.
(3), pick up the ground garbage, according to the order of the production line from the inside out one by one.
(4), on time dumping trash cans, garbage inside the garbage, and
check, according to the provisions of strict classification, the
production line administrator or security inspection after delivery to
the designated garbage room classification placed.
(5), from the top down the use of clean paper or clean cloth clean indoor glass, walls, shelves,
(6), the use of clean dust pushed from the inside out carefully to the ground dust, cleaning. The ground has garbage, stains, water, etc. in a timely manner with a clean cloth clean.
(7), the use of production line staff rest meal time on the production
line, workstations, under the chair to clean up the ground.
(8), regular cleaning of the ceiling, air conditioning outlet, ceiling
lamp cover, elevated floor, cleaning procedures and the use of
materials must apply for approval of the Ministry of Commerce, and the
use of holidays and work gap as planned.
(9), cleaning work is completed after the need to receive all the
cleaning supplies designated clean rooms, and ordinary tools to
distinguish between, to avoid cross-contamination, neatly placed, not
free to put in the clean room.
5, attention (depending on the requirements of different levels)
(1), must be discarded bulky hood, mask, beard hood, shoe cover and latex gloves, must not be used again.
(2), staff dress, ready to work.
(3), do not allow personal items, such as coats, hats, wallets, keys.
(4), employees should replace the clothes and jewelry for pollution.
(5), employees should wear clean room hoods, gloves, rabbit suits and socks. Damaged or contaminated blouse or gown should be replaced immediately. Dress should meet the specified dressing steps.
(6),
do not allow any ordinary paper mats, notebooks, manuals and tablet; do
not allow ordinary writing pencils, pens, eraser, crayons or chalk;
notes lint paper, plastic paper and the like, The use of ball-point pens or other non-dust-producing appliances;
blue lines, specifications or other instructions should be covered with
plastic film, lint or other dust-free appliances.
Clean room regular cleaning standards
Clean, dustless and sterile conditions are indispensable to most modern manufacturing industries. There is no clean production conditions, the product may be contaminated and failure, it may cause harm to the human body. The
purpose of cleaning the clean room is to collect all unwanted
contaminants from the clean room or clean area with varying degrees of
importance (for cleanliness) and remove them The
Serial number
In the case of
content
In the case of
cycle
In the case of
Cleaning requirements and inspection standards
1.
In the case of
floor
In the case of
Once a day
In the case of
Use a vacuum suction or a special mop for towing
Visual conditions can not have any stains and water marks
2.
In the case of
Wall
In the case of
once a week
In the case of
The walls once a week to light can not have any stains and water marks
To light can not have any stains water marks
3.
In the case of
All doors and windows and handrails
In the case of
once a week
In the case of
Wipe clean with dust
To light can not have any stains and water marks
Door handles, chains and other metal objects can not rust or stains
4.
In the case of
Telephone, walkie-talkie, fire extinguisher
In the case of
once a week
In the case of
Wipe clean with dust
Do not have stains in the visual condition
5.
In the case of
trash can
In the case of
Twice a day
In the case of
Regularly clean up garbage and replace garbage bags
The height of the garbage can not exceed the barrel height
6.
In the case of
Foot pad
In the case of
From time to time
In the case of
From time to time replacement and supplement
Can not be too dirty to use (serious dirty or no sticky)
There are dirty updates at any time
7.
In the case of
Buffer / break room
In the case of
Once a day
In the case of
The floor is diverted with a di dipper for water
Visual can not have stains and chemicals, cartons and other residues
Wipe clean with dust
8.
In the case of
Dust free clothing
Personal dusty hanger
In the case of
Twice a day
In the case of
Wipe clean with dust
Do not place anything on your personal wardrobe
9.
In the case of
Material entry
Out of the demolition area
In the case of
Twice a day
In the case of
The floor is wiped with a vacuum wipe and a mop
Do not have cartons and chemicals
Door panels, wall panels to clean cloth can not have stains and dust
10.
In the case of
locker room
Clean clothes
Clean shoes
In the case of
From time to time
In the case of
From time to time sorting and sorting placement
Do not have non-related items stay
Clean clothes, shoes, once a week to replace the job and point income
Clean with a clean cloth can not have dust, the floor to vacuum suction and a special mop to wipe clean
Supplies such as mouth, hair cover, gloves and other items from time to time to add
11.
In the case of
Shoe area
In the case of
Once a day
In the case of
Wipe clean with a special suction mop, wall panels can not have any stain marks
The shoe cabinet wipes clean with a clean cloth, and the wallboard can not have odor other than deodorization
12.
In the case of
cleaning supplies
Tool storage area
In the case of
once a week
In the case of
12 Cleaning supplies Tool storage area Weekly cabinets Wipe clean with dust-free cloth No dust
Whether the internal utensils are clean and neatly stained
13.
In the case of
Cleaning room
In the case of
Once a day
In the case of
Wipe clean with dust
Visual can not have stains and water marks
14.
In the case of
Return room
In the case of
once a week
In the case of
The air return room is fixed once a week with a vacuum cleaner and a suction mop
Use a vacuum suction and a special mop for towing
Do not have stains and water marks in the visual condition
Into the clean room Note:
1, in the clean room to move when the action should not be light to run, in order to avoid the impact of laminar flow.
2, working in a clean room, if the suspension operation can not be a mask and gloves to do a short break.
3, into the clean room must go through the dust room.
4, into the clean room staff must wear a clean clothes and shoes.
5, equipment maintenance If necessary to sit, lying or lying, the need
to be covered with a proprietary plastic sheeting on the ground.
6, remove the dusty clothing must first remove: masks, clean shoes,
dust-free clothing, hair cover, gloves, and according to marked
classification placed or discarded.
7, the correct way to wear a mask is to clean the top of the hood behind the buckle buckle.
8, clean room staff can not carry non-clean notebook into the clean room.
9, clean room shall not use pencil, writing all use of the pen, writing errors can not be used to amend the amendment.
10, with the requirements of dust-free clothing is the mouth cover the
nose, the hair should not be exposed, sleeves, mouth to be wrapped
around the mouth, to avoid wrist exposed.
11, clean indoor elevated floor can not be free to pull, so as not to affect the laminar flow and personnel safety.
12, after dressing, can not enter the monitoring room.
13, into the wafer area with the people are not allowed to use cosmetics (such as lipstick, blush, perfume, etc.).
14, into the dust room Note: not parallel, the two body should be kept
more than 30 cm, his hands waist, slow through, is strictly prohibited
to run.
15, the way to reduce the dust is: keep the head, hands, body clean.
16, in the dust room cleaning dust, the two body before and after to be kept more than 30 cm.
17, wearing a clean clothes before the need to tie the hair and then put on the hair cover.
18, people are the largest source of clean room pollution.
19, the last action with a clean clothing is to check the clothing.
20, the following stationery is not clean room dedicated: water-based
signature pen, pencil, correction fluid, photocopying paper.
21, into the clean area all staff are not allowed to eat anything (such as: chewing gum)
22, no one can be in the work has nothing to do, can not bring into the clean room items in the dusty clothes in the bag.
Concerned about